Nortel 1120E Administration Manual page 73

4
5
Follow the next procedure to download the minimum required version of
UNIStim Firmware automatically through TFTP on bootup.
Copyright © 2008, Nortel Networks
.
The Technical Support page appears.
3. Enter IP Phone 1120E in the Knowledge and Solution Engine
box.
4. Select SOFTWARE in the ALL TYPES scroll down menu.
5. Press the gray arrow at the end of the Knowledge and Solution
Engine box to obtain the Search Results.
6. From the Search Results, select the appropriate version of
the UNIStim Firmware for the IP Phone 1120E, for example, IP
Phone 1120E Release 0625C23
7. Place the selected firmware in the correct directory on the
provisioning server.
In the IP Phone 1120E Network Configuration menu, change the
TFTP server address and enter the correct TFTP server address.
This can be the provisioning server as defined in the chapter
"Configure the provisioning server" (page
Select the Apply&Reset Context-sensitive soft key to save the
settings and reset the IP Phone 1120E.
The IP Phone 1120E downloads the firmware file. The display
shows [FW] reading...
If the download is successful, the display shows [FW] writing...
and the blue LED flashes.
After the firmware image is downloaded to the IP Phone 1120E, the
display shows [FW] finished..., the blue LED stops flashing, and the
IP Phone 1120E resets.
The IP Phone 1120E registers to the TPS with the new firmware
version.
If the upgrade is unsuccessful, see the chapter
troubleshooting" (page 123)
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
Upgrade to the Minimum UNIStim Firmware 73
in the section Download failures.
—End—
27 May 2008
25).
"Maintenance and