Nortel 1120E Administration Manual page 64

64 Physically install the IP Phone 1120E
6
7
8
9
10
Copyright © 2008, Nortel Networks
.
Install the Ethernet cable connecting the PC to the IP Phone 1120E
(optional). If connecting PC Ethernet through the IP Phone 1120E,
connect one end of the PC Ethernet cable to the IP Phone 1120E
using the RJ-45 connector and thread it through the channel.
Connect the other end to the LAN connector on the back of the PC.
Install additional cables. If applicable, plug in optional USB devices.
Connect the Ethernet cable to the LAN Ethernet connection. If using
an AC power adapter, plug the adapter into an AC outlet.
Wall-mount the IP Phone 1120E (optional). The IP Phone 1120E
can be mounted either by: (method A) using the mounting holes on
the bottom of the IP Phone 1120E stand, or (method B) using a
traditional-style wall-mount box with RJ-45 connector and 15-cm
(6-inch) RJ-45 cord (not provided).
Replace the stand cover. Ensure that all cables are neatly routed
and press the stand cover into place until a click is heard.
Put the IP Phone 1120E in the wall-mount position (optional). If the
IP Phone 1120E is to be mounted on the wall, put it in the wall-mount
position by holding the tilt lever and pressing the IP Phone 1120E
towards the base until the IP Phone 1120E is parallel with the base.
Release the tilt lever and continue to push the IP Phone 1120E
towards the base until an audible click is heard. Ensure the IP Phone
1120E is securely locked in position.
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
—End—
27 May 2008