Ricoh FT8680 Service Manual page 347

ARDF
12.13 EXIT ROLLER REMOVAL
[A]
[L]
[M]
[N]
1. Remove the inverter cover and the transport unit cover.
2. Disconnect the 4 connectors [A].
3. Loosen the 2 screws [B], remove the 2 screws [C], and remove the
transport drive unit [D].
4. Mark the position of the exit roller drive belt tension bracket [E] and
loosen the screw [F].
5. Remove the gear support plate [G] (3 screws).
6. Remove the 2 E-rings [H], exit roller drive pulley [I], pin [J], and bushing
[K].
7. Remove the E-ring [L] and bushing [M].
8. Remove the front and rear lower screws [N] fixing the exit stay [O].
9. Rotate the exit stay clockwise and replace the exit rollers [P].
NOTE: When reassembling the machine, install the one way gears so
that the white gear [Q] is in the lower left and the black gear [R] is
in the upper right.
[C]
[O]
[P]
[K]
[N]
5-118
[I] [H]
[J]
[H]
31 July 1995
[B]
[D]
[R] [Q]
[G]
[E]
[F]
A171R673.img