Ricoh FT8680 Service Manual page 305

REGISTRATION AND TRANSPORT
8.5 RIGHT VERTICAL TRANSPORT UNIT REMOVAL
[A]
[C]
1. Remove the 1st and 2nd tray units.
2. Pull out the right vertical transport unit [A].
3. While supporting the vertical transport unit, remove the 3 screws [B].
Otherwise, it may cause the vertical transport unit fall down.
4. Push the upper accuride [C] into the main body while supporting the
vertical transport unit.
5. Lift up the vertical transport unit and remove it.
NOTE: When reinstalling the vertical transport unit, align the front side
positioning pin [D] to the front hole of the vertical transport unit,
then align the rear pin [E] with the rear hole. Next, pull out the
upper accuride and align the screw holes.
[E]
[D]
5-76
31 July 1995
[B]
A171R636.img