Ricoh FT8680 Service Manual page 297

1ST, 2ND, AND 3RD TRAYS
4. Rear wire replacement
a) Insert the blue bead [A] of the new wire into the slot of the drive pulley
[B] and wrap the wire around the drive pulley twice clockwise.
b) String the wire over all pulleys, except the tension pulley [C].
c) Wrap the other end of the wire around the drive pulley 3.5 times
clockwise and insert the bead into the slot of the drive pulley as shown.
d) Insert the support beads [D] into the slots of the lift rods [E].
e) String the wire over the tension pulley.
[A]
[B]
5-68
31 July 1995
[D]
[E]
[C]
A171R611.img