Ricoh FT8680 Service Manual page 175

INSTALLATION PROCEDURE (LCT)
[F]
[B]
5. Remove the left lower cover [A] (3 screws) of the copier and remove the 3
caps [B]. Remove the upper by-pass feed cover [C] (2 screws: U.S.A.
version only) and lower by-pass feed cover [D] (2 screws).
6. Remove the left rear cover [E] of the copier and cut 2 binds [F] for the
LCT interface harness by the pliers.
7. Remove the dummy connector [G].
NOTE: The dummy connector is required when operating the copier
without the LCT. Keep it for future use.
8. Secure the ground wire [H] to the copier (1 grounding screw).
[H]
[G]
[A]
A171I531.img
[E]
3-16
31 July 1995
[C]
[D]
[D]
A171I538.img
A171I535.img