Installing A Drive In Bay 4 - IBM Aptiva Handbook

Installing a drive in bay 4

Bay 4 can hold up to a 3.5-inch half high drive, such as a diskette or tape drive.
1.
Insert the drive into the bay. Align the screw holes
and insert the three screws.
(Front View)
92 Chapter 7: Working with adapter cards and drives
2.
Connect the power and signal cables to the
drive.
Power Cable
Signal Cable
Drive
If you add a diskette drive or a tape drive that attaches to
the Diskette connector, make sure the signal cable you
plug into the drive is attached to the Diskette connector on
Note:
the system board. To identify the Diskette connector on the
system board, see "Identifying signal cable connectors" on
page 86.
Drive
(Back View)