IBM Aptiva Handbook page 142

Table 7: Error codes, descriptions, and corrective actions
Error Code Description
162 (cont)
163 Date and Time Incorrect
151
Notes:
1. An X shown as part of the error code in this table represents any number between 0 and 9.
2. If any of these problems continue after taking the actions listed, see your online Aptiva Helper for information on running
diagnostics. If you need service, see the HelpWare book.
126 Chapter 8: Diagnosing and recovering from problems
Here's what to do:
If you are not using Rapid Resume, follow these steps:
1. Press Enter while the error message is displayed. This starts the Setup
Utility.
2. Look through the Setup Utility and verify that the options with
them were supposed to change.
3. If the settings are correct, save the settings when you exit the Setup Utility.
4. If options changed that were not supposed to change, see the HelpWare
book for information on obtaining service.
For more information on using the Setup Utility, see "Using the Setup
Utility" on page 31.
1. The clock module on the system board may not be set correctly. To set the
correct date and time, press Enter while the error message is displayed.
This starts the Setup Utility. For instructions on using the Setup Utility to set
the date and time, see "Setting the date and time" on page 49.
2. You may need to replace the system battery. For these instructions, see
"Replacing the system battery" on page 74.
next to