Installing A Drive In Bay 1 Or Bay 2 - IBM ThinkCentre 8143 User Manual

Installing a drive in bay 1 or bay 2

1. Remove the cover. See "Removing the cover" on page 10.
2. Remove the front bezel by pushing the blue release button as shown.
3. Remove the static shield from the drive bay by using a flat-blade screwdriver
to gently pry it loose.
4. Remove the plastic panel in the bezel for bay 2 by squeezing the plastic tabs
that secure the panel on the inside of the bezel.
5. PATA drives must be jumpered as either a master or a slave device. SATA hard
disk drives do not require either a master or a slave device jumper. If you are
installing an SATA hard disk drive, continue to step 6 on page 18.
v If you are installing the first optical drive, set it as a master device.
v If you are installing an additional optical drive, set it as a slave device.
v If there is a combination of optical and parallel ATA hard disk drives in bays
1 and 2, set the hard disk drive as a master device and the optical drive as a
slave device.
Chapter 1. Installing options
17