Tektronix Phaser 360 User Manual page 195

Color printer
Hide thumbs Also See for Phaser 360:
Table of Contents

Advertisement

Printing and installation problems (cont'd.)
Symptom
The Ready message or
the printer's name is
displayed, but the file
does not print.
The printer takes too
long to warm up (more
than 30 minutes).
A file does not print and
a virtual memory (VM)
error appears.
A file does not print, or it
prints unexpected data.
The printout is delayed.
The printer outputs two
prints after a jam is
cleared.
Files sent during
power-up do not print.
The printer receives a file
on the parallel port but
does not print.
Solution
Make sure that the Phaser 360 printer is the selected
printer. Try printing the same file to another PostScript
printer. If the file prints, then the problem could be with
the interface cable. Refer to "Interface cables and
adapters" on page 10-7 for information on ordering
Tektronix interface cables.
Turn the printer's power off, wait at least 15 seconds,
and then turn the power on again.
Refer to "Using a PostScript error handler" on
page 8-27 for details on using the Tektronix Error
Handler to determine the cause of the problem.
Make sure that the vent on the right side of the printer
is not blocked. Allow at least 5 cm (2 in.) clearance on
each side of the printer.
You may need to expand printer memory. Refer to
"Memory upgrade" on page 10-5 for more information.
Make sure that the printer is set up to receive the
appropriate language (PostScript, HP-GL, or PCL5) for
that file. Refer to "Checking the printer's language
mode" on page 8-25 for more information.
See "Printer standby modes" on page 6-8.
The printer is cleaning the print drum and reprinting the
image. Refer to "Media jams and misfeeds" on
page 8-15.
Before printing a file, wait until the printer's front panel
displays Ready or the printer's name.
Do not set the wait timeout to 0.
Print files should not have extra characters after the
End-of-Job character (Ctrl-D).
Refer to the on-line manual on the printer's CD-ROM for
information on setting timeouts and the Ctrl-D character.
Troubleshooting
8-9
User Manual
8

Advertisement

Table of Contents
loading

Table of Contents