Media Tray Settings - Tektronix Phaser 360 User Manual

Media tray settings

You can control the source of a print job from your computer. The media
tray choices available in your application menus depend on the number and
types of trays you have in use, the type of driver you have installed from the
printerÕs CD-ROM, and the printerÕs default setting.
If this selection appears in your menu, it acts as the default. The
AutoSelect
printer automatically prints from the upper tray if you are printing in a
single-tray conÞguration. If you have a Lower Paper Tray Assembly, it
prints from the lower tray. If you have trays in both slots, the printer
automatically switches to the other tray if one of the trays runs out of paper.
This is the initial setting for Windows drivers. If you select Paper and
Paper
the standard media tray is installed, the printer will print on whatever
media is loaded in the upper tray. If you have the Lower Paper Tray
Assembly installed, selecting Paper feeds paper from the lower tray. If you
select Paper and the transparency tray is installed, the printer will not print
and will prompt you to load paper.
Select Transparency whenever you print transparencies. If
Transparency
you use a dedicated transparency tray, you can print from your computer. If
you print transparencies from the standard paper tray, you must conÞrm the
print selection at the printerÕs front panel. Refer to page 4-14 for directions
on printing transparencies from the standard paper tray.
Select Manual Paper when you wish to hand feed single
Manual Paper
sheets of paper or card stock (up to 220 g/m
from your computer, then feed the paper into the printer when prompted by
the front panel. Refer to ÒWhen to use the manual-feed slotÓ on page 4-16
for more details on using manual feed.
Manual Transparency
transparency sheets into the printer. Refer to ÒWhen to use the manual-feed
slotÓ on page 4-16 for more details on using manual feed.
Use these settings to change printing trays if you have
Upper/Lower
installed the optional Lower Paper Tray Assembly. See ÒChanging the
default media tray settingÓ on page 4-10.
2 [80 lb.]). Select this option
Select Manual Transparency to hand feed single
Printing Basics
User Manual 4-9
4