Tektronix Phaser 360 User Manual page 155

Install the new maintenance tray by sliding it into the printer.
4.
Make sure the tray slides in straight on both sides.
Using both thumbs, push the tray in Þrmly until it latches.
5.
Close the front cover and wait for the printer to warm up (about
6.
15 minutes).
To prevent leaking, seal the used maintenance tray in the plastic
7.
bag from the new (replacement) maintenance tray. Treat the used
maintenance tray as normal ofÞce waste.
Caring For Your Printer
9922-38
9922-150
7-13
User Manual
7