Letting The Printer Warm Up - Tektronix Phaser 360 User Manual

Letting the printer warm up

After you have installed the maintenance tray and the media tray, allow the
printer about 15 minutes to warm up and perform self-tests. As the printer
warms up, note the following:
Front panel display. When you Þrst turn on the printer, two
indicator lights come on, the power light and the error light.
During the warm-up cycle, the top power indicator blinks on and
off, the error light goes out, and the front panel displays a series of
ÒWarming upÓ messages. A percentage value is shown to indicate
the progress of the warm-up cycle. The cycle is complete when the
front panel displays 100%, then Ready.
Startup noises. As the printer initializes, you will hear a series of
noises; these are normal and are not an indication of problems
with the printer.
Cleaning Page. The printer outputs a color-striped ÒCleaning
PageÓ as part of its self-maintenance. Refer to page 7-16 for more
information on the Cleaning Page.
Startup Page. The printer outputs a page that lists your printerÕs
name and serial number, the number of pages printed, installed
interface ports, and other information. This Startup Page
automatically prints whenever you turn on your printer. To turn
off the Startup Page, refer to page 6-6.
Ready message. The front panel displays Ready or the printerÕs
name when the printer is available for printing.
Getting Set Up
User Manual 2-23
2