Tektronix Phaser 360 User Manual page 151

When you open the front cover, the following message appears:
2.
Waste Liner (A) Full
Remove Tray (B)
Grasp the maintenance tray by the front edge (marked with a blue
3.
ÒBÓ label) and lift up while sliding it out of the printer.
Note
Once the maintenance tray has been partially used, it will leak
drum fluid if tipped. Place the maintenance tray on a flat surface
after removing it from the printer. Contact with the drum fluid
poses no known health risk. Refer to "MSDS for silicone oil
(drum fluid)" on page 11-6 for more information.
Caring For Your Printer
9101-53
User Manual
7
7-9