Tektronix Phaser 360 User Manual page 189

Front panel messages (cont'd.)
Message
Jam:Open Front
Cover
Jam:Remove Lower
Tray
Jam:Remove Upper
Tray
Jam:Retry Manual
Feed
Lower Media Tray
Empty
Maintenance Tray
(B) Low
Manual Feed Paper
Media Tray Empty
Out of Ink
Replace Lower
Media Tray
Replace Media Tray
Replace Upper
Media Tray
Tray (B) Locked
Unlock Transit
Restraint
Action
Open the front cover and remove the paper jam from
the manual-feed slot or behind the front cover. You may
need to push on both sides of the maintenance tray to
relatch it or clean the upper or lower paper-feed rollers.
There is a paper jam at the lower paper tray. Remove
the tray and the jammed paper.
There is a paper jam at the standard media tray.
Remove the tray and the jammed paper. You may need
to run the Clean:Paper Jams routine if this problem
persists.
Remove the media from the manual-feed slot and
reinsert it.
Add paper to the lower paper tray.
The maintenance tray is nearly empty of drum fluid.
Open the front cover, remove the maintenance tray,
and replace it with a new one.
The printer requires a sheet of paper for self-cleaning,
but the media tray contains transparencies. Feed a
sheet of paper into the manual feed slot.
Add paper or transparencies to the media tray.
One or more ink bins is empty. Load the appropriate
ink stick(s).
Insert the lower paper tray.
Insert the standard media tray.
Insert the standard media tray.
The printer has locked the maintenance tray because
hot ink is present. Close the front cover and wait for a
few minutes before trying to remove the maintenance
tray.
Unlock the transit restraint on the right side of the
printer before sending print jobs.
Troubleshooting
8-3
User Manual
8