Step 2: Loading Media And Setting The Height; Loading Media (Media Setup) - Roland VersaUV LEF-300 First Step Manual

STEP 2: Loading Media and Setting the Height

CAUTION Never load media that weighs over 8 kg (18 lb.). To avoid injury, handle the media with care.

1. Loading Media (Media Setup)

NOTE
Be sure to hold the handle of the front cover and open and close it gently.
MEMO
• Printing tests are used to check that no dot drop-out occurs. For printing tests, use media for testing (width
80 × height 70 mm, width 3.1 × height 2.8 in. or bigger), not the media you will actually use.
• The media can be set anywhere as long as it does not protrude from the flat table.
• Be aware that when there are folds or kinks in the media, they might hit the interior of the printer and cause
damage.
1.
Check that the following screen is displayed.
SETUP MEDIA
MEMO
When this screen is not displayed, you cannot perform setup. To perform setup, make sure that there is
nothing placed on the flat table, and then press [SETUP] for one second or longer. The flat table will come
forward into a position in which you can set up the media.
2.
Open the front cover.
3.
Secure the media in place.
Securing the media in place with the suction function
Press the [PAUSE/VACUUM] button.
You can use this function to secure media such as thin paper in place on the flat table by way of the suction
from the bottom of the flat table. However, you may not be able to use this function to secure some types of
media in place.
Media that cannot be secured in place with the suction function
• Curled media
It is not possible to use the suction function to secure the
media in its entirety because the edges of the media curl up.
• Thick media
First Time Printing
47