Avaya G350 Installing And Upgrading page 98

Upgrading IP phone configuration and firmware files
Note:
The G350 uses the SSH protocol to support the use of SCP for secure file
Note:
transfer. When using SCP, the G350 is the SCP client, and an SCP server must
be configured on the management station. For more information about
establishing an SCP session, see Administration for the Avaya G250 and Avaya
G350 Media Gateways, 03-300436.
1. Check the available memory size for the image files using the show
application-memory command. If the memory size needs to be changed, proceed to
step 2, otherwise proceed to step 6.
2. Set the memory size for the image files using the ip tftp-server file-system
size command.
3. Copy the running configuration to the start-up configuration using the copy
running-config startup-config command.
4. Reset the G350 using the reset command.
5. From the Avaya Support website, obtain the desired phone upgrade files (script files, boot
image files, phone application image files), using either of the following methods:
- Download the phone upgrade files to a remote FTP/TFTP/SCP server. Note that SCP
can be used to download script files but not image files.
- Download the upgrade files to a laptop and copy them to a USB mass storage device.
6. Copy the script files for the IP phone family.
- To copy from the remote FTP/SCP/TFTP server, use one of the following commands:
●
●
●
- To copy from the USB device, insert the USB device into the G350 USB port and copy
the files to the resident TFTP server using the copy usb phone-script command.
7. Copy the boot image files for up to two IP phone types.
- To copy from the remote FTP/TFTP server, use either the copy ftp phone-image
command or the copy tftp phone-image command for each IP phone type.
- To copy from the USB device, insert the USB device into the G350 USB port and copy
the files to the resident TFTP server using the copy usb phone-image command.
8. Copy the phone application image files for up to two IP phone types.
- To copy from the remote FTP/TFTP server, use either the copy ftp phone-image
command or the copy tftp phone-image command for each IP phone type.
- To copy from the USB device, insert the USB device into the G350 USB port and copy
the files to the resident TFTP server using the copy usb phone-image command.
9. Reset the phones and wait for the installation to be completed.
98 Installation and Upgrades for the Avaya G350 Media Gateway
copy scp phone-script
copy ftp phone-script
copy tftp phone-script