Chapter 7: Adding Media Modules And Devices; Adding A Media Module; Adding Voice Modules; Adding Wan And Lan Modules - Avaya G350 Installing And Upgrading

Chapter 7: Adding media modules and
When adding new devices to the G350, consult your project manager for topology requirements
for specific ports to be connected to specific devices.

Adding a media module

Various media modules including voice modules or WAN and LAN modules can be added to the
Avaya G350 Media Gateway.

Adding voice modules

You can hot-swap voice modules. This means that you can add or remove a voice module in the
Avaya G350 Media Gateway while the system is running, without any disruption to your
network. Configuration of the G350 is not necessary when you add or remove a voice module.
Configuration is only necessary when you add telephones, fax machines, and trunks to the new
module. See Adding a telephone
Some configuration of the Avaya Aura Communication Manager is necessary when you install
an MM710, MM710B, MM720, or MM722 media module. See Administrator's Guide for Avaya
Aura Communication Manager, 555-233-506. Also, for an MM710, MM720, or MM722, it is
usually advisable to set the media module as the synchronization source of the G350. For
information about setting the synchronization source of the G350, see the Avaya G250 and
Avaya G350 CLI Reference, 03-300431.

Adding WAN and LAN modules

You can hot-swap WAN and LAN modules. This means you can add or remove a WAN or LAN
module in the Avaya G350 Media Gateway while the system is running, but the G350 resets
when you add or remove the module. However, hot insertion and removal is not recommended
in most cases. Because hot insertion or removal resets the G350, any translation and other data
that is in the running configuration but has not been saved to the startup configuration will be
lost.
devices
on page 76 and Adding a trunk on page 77.
Issue 7 November 2009 75