Figure 4: Attaching a bracket to each side of the G350
Fastening the G350 to the wall
Position the G350 so that its front panel is facing up. If the wall is flat, you can screw the G350
directly to the wall. If the wall is not flat, screw a plywood sheet at least ¾ in (20 mm) thick and
at least 4 x 4 ft (1.2 x 1.2 m) in size, and fasten the G350 to the board.
Placing the G350 on a table
If you install the G350 as a tabletop unit, affix the provided rubber feet to the underside of the
G350.
1. Remove the four feet from their packaging.
2. Turn the G350 upside down.
3. Position each foot into one of the mounting sites, near each corner of the chassis.
Step 2: Installing the media modules
When the G350 chassis is installed, you can insert the media modules. Each module is shipped
with two thumb screws for securing the module in the G350 chassis.
Note:
The required media modules are sometimes pre-installed in the G350 chassis. If
Note:
this is the case, skip this step. Read this section only if the media modules are not
pre-installed, or if you want to replace modules or add new media modules.
Step 2: Installing the media modules
Issue 7 November 2009
29