Connecting The Telephone To The G350; Connecting An Isdn Bri Station; Connecting One Isdn Bri Station To One Isdn Port; Connecting Two Isdn Bri Stations To One Isdn Port - Avaya G350 Installing And Upgrading

Connecting the telephone to the G350

1. Wire a telephone to a LAN port on the G350. If the IP telephone will be powered through
the G350, make sure you use a 10/100 Ethernet port on an MM314 Media Module or
MM316 Media Module installed in slot V6 of the G350. In this case, you do not need to
plug the IP telephone into a power supply.
2. Plug the telephone into the telephone port.
3. If the IP telephone will be powered independently, plug the IP telephone into a power
supply and check that the IP telephone is powered up.

Connecting an ISDN BRI station

Each ISDN port on the MM720 media module supports up to two ISDN BRI stations.
Note:
The MM720 BRI media module cannot be administered to support both BRI
Note:
trunks and BRI stations at the same time. However, the MM720 BRI media
module supports combining both B-channels together to form a 128-kbps
channel. CM 3.1 enables combining B-channels, using BONDing, to form a
higher bandwidth connection.
Finally, if the MM720 BRI media module is administered to support BRI stations, it
cannot be used as a clock synchronization source.

Connecting one ISDN BRI station to one ISDN port

Connect the station via a standard 8-pin BRI cable to one of the ISDN ports on an MM720
media module.

Connecting two ISDN BRI stations to one ISDN port

1. Connect each station to an RJ-45 splitter that provides two RJ-45 4-pair jacks, and one
RJ-45 male connector. See
2. Connect the male connector of the splitter to one of the ISDN ports on an MM720 media
module.
Step 1: Connecting data and voice devices
Figure 10 for the correct wiring for the splitter.
Issue 7 November 2009 47