Lsp Failover Testing - Avaya G350 Installing And Upgrading

Hide thumbs Also See for G350:
Table of Contents

Advertisement

After installation

LSP failover testing

If you have an S8300 Server installed in the G350 and configured as an LSP, you need to
perform a test to make sure that the LSP takes over control of the G350 if the G350 becomes
disconnected from the primary MGCs (Media Gateway Controller).
Note:
If SLS mode is enabled and the primary controller and LSP both fail, then the
Note:
G350 enters SLS mode.
1. Verify that valid translations are file synchronized to the LSP by logging into Avaya Aura
Communication Manager from the LSP and listing either stations or trunks, see
Administering Avaya Aura™ Communication Manager, 03-300509. Verify that the list of
stations or trunks is valid. If the files are not synchronized, verify that you have correctly
configured the required IP address(es) for the primary controller(s) (MGC). If you are using
Avaya IW to configure the G350, the following are key actions that must be done in the
wizard to ensure correct IP address configuration:
a. In the Usage options screen, select the one of the following usage options that
corresponds to the correct primary controller type:
If you selected the correct usage option, the Primary Controller IP Address screen
appears later in the wizard, and calls for the required primary controller IP addresses
for your primary controller type. The following IP addresses need to be configured for
each primary controller type:
Primary media
gateway controller
S8300X
S85XX
b. In the Primary Controller IP address screen, enter all the required IP addresses for the
primary controller type.
There may be a delay after running AIW until the LSP is registered with the primary
MGC and the translations are file synchronized.
72 Installation and Upgrades for the Avaya G350 Media Gateway
Install an LSP that is associated with an S8500 Primary Controller.
Install an LSP that is associated with an S8300 Primary Controller.
Number of IP addresses
to be configured
1
2
IP addresses to configure
The IP address of the
primary S8300X
The IP address of the
S85XX's Control-LAN card
(CLAN) and the IP address
of the S8500

Advertisement

Table of Contents
loading

Table of Contents