Avaya G350 Installing And Upgrading page 36

Installing the Avaya G350 Media Gateway
3. Apply firm pressure to the front panel of the media module until it is flush with the front
panel of the gateway.
4. Tighten each of the spring-loaded captive screws by turning them four times with a
screwdriver.
5. Apply firm pressure to the front panel of the media module to ensure full engagement of
the connectors.
6. Lock the media module into the chassis by tightening the spring-loaded captive screws on
the front of the module.
Tip:
Use the show mg list_config CLI command to see whether the gateway has
Tip:
identified all the installed media modules correctly. If the gateway does not
identify a media module, re-install the media module.
!
DANGER:
To prevent access to electrical hazards by unauthorized personnel and to ensure
DANGER:
continued compliance to international radiated emissions requirements, all
captive screws must be securely tightened such that they cannot be loosened
without the use of a tool.
!
WARNING:
After you have connected telephones to the various media modules, be sure to
WARNING:
add circuit protection to the lines.
36 Installation and Upgrades for the Avaya G350 Media Gateway