Sony HDS-7100 User Manual page 134

Adjusting the wave pattern
Stopping the wave motion – F3 (LOCK)
Adjust the parameters for the following items.
When F2 (MODE) is set to "H & V" then the "Modulation H" and
"Modulation V" items are enabled; when F2 (MODE) is set to
"SLANT" or "SIZE" then the "Modulation H" and "Slant Angle"
items are enabled.
Item Setting
"Modulation Nature of the
H" horizontal
modulation
"Modulation Nature of the
V" vertical
modulation
"Slant Orientation of
Angle" wave effect
Amp
Press F3 (LOCK), turning it on, to stop the wave motion. Press it
again to restart movement.
Knob adjustments of parameters
Left ("Amp"): amplitude of the waves (0 to
100%)
Center ("Freq"): degree of fineness of the
waves (0 to 100%)
Right ("Sped"): direction and speed of
wave motion (–100 to +100%)
(When F3 ("LOCK") is on)
Right ("Ofst"): phase offset and direction
of the waves (–16 to +16)
Left ("Amp"): amplitude of the waves (0 to
100%)
Center ("Freq"): degree of fineness of the
waves (0 to 100%)
Right ("Sped"): direction and speed of
wave motion (–100 to +100%)
(When F3 ("LOCK") is on)
Right ("Ofst"): phase offset and direction
of the waves (–16 to +16)
Right ("Angl"): Orientation of wave
rotation (–8 to +8)
Ofst
Chapter 5 Special Effects Operations
5-53