Sony HDS-7100 User Manual page 256

Changing the three-dimensional parameter values for the
current keyframe
2
Refer to the following table, and press the appropriate button
(ASP/SKEW/PERS, LOC SIZE, LOC XYZ, AXIS LOC, or
ROT button in the transformation mode selection section) for
the required parameters.
To display the spin parameters, press F7 (SPIN).
Button in the Button in the
function allocation transformation
section mode selection
section or F7
SRCE ASP/SKEW/PERS
LOC SIZE
LOC XYZ
AXIS LOC
ROT
SPIN (F7) or SHIFT +
ROT button
TRGT ASP/SKEW/PERS
LOC SIZE
LOC XYZ
AXIS LOC
ROT
SPIN (F7) or SHIFT +
ROT button
In the 3D VIEWER menu, the line for the current keyframe is
shown in green. Use the following procedure to change the
parameter settings on this line.
1
Click with the mouse on the required item, or delegate the
trackball to cursor movement then press the SEL/FINE button.
2
Enter the parameter value from the numeric keypad, and press
the ENTER button.
Displayed parameters
SKEW X, SKEW Y, ASP
LOC X, LOC Y, SIZE
LOC X, LOC Y, LOC Z
AXIS X, AXIS Y, AXIS Z
ROT X, ROT Y, ROT Z
SOURCE SPIN X,
SOURCE SPIN Y,
SOURCE SPIN Z
PERS X, PERS Y, PERS Z
LOC X, LOC Y, SIZE
LOC X, LOC Y, LOC Z
AXIS X, AXIS Y, AXIS Z
ROT X, ROT Y, ROT Z
TARGET SPIN X,
TARGET SPIN Y,
TARGET SPIN Z
Chapter 9 Status Displays
9-5