Sony HDS-7100 User Manual page 272

Enabling control from a switcher – F6 (SW'ER IF)
Setting up the state to be recalled at power on – F7 (PWR ON
DEFINE)
Setting up the state to be recalled with the CLR WORK BUFF
button – F8 (CLR WRK DEFINE)
To control the internal DME from a switcher control panel
connected to the SWITCHER PANEL connector on the rear panel
of the processor, press F6 (SW'ER IF), to select "DME".
Use the following procedure.
1
Set the system up with all the settings, including setup data,
three-dimensional transformation parameters and effects, to
the required initial state.
2
In the OPERATION menu, press F7(PWR ON DEFINE).
This stores the state of the settings at the time the button is
pressed.
This state is recalled at power on, provided that the "Power
On" item is set to "User Define".
Use the following procedure.
1
Set the system up with all the settings, including three-
dimensional transformation parameters and effects, to the
required state.
2
In the OPERATION menu, press F8 (CLR WRK DEFINE).
This stores the state of the settings at the time the button is
pressed.
This state is recalled with the CLR WORK BUFF button,
provided that the "Clear Work Buff" item is set to "User
define".
Chapter 10 Setup Operations
10-9