Sony HDS-7100 User Manual page 296

Selecting software before installing – F3 (MANUAL INSTALL)
Setting up the state to be recalled at power on after installing
software
Use the following procedure.
1
Use J or j button to select the required software and then
press F8 (ON/OFF).
2
Press F3 (MANUAL INSTALL).
The installation begins.
Press F4 (RETRY) to restart when an error occurs while the
installation is executed.
After installing a new software version in the processor, the
previous setup data is preserved. Use the following procedure to
change the settings to be recalled at power on after upgrading.
1
In the OPERATION menu (menu page 702), press F2
(POWER ON), to select "User define".
For details of the OPERATION menu, see page 10-7.
2
Momentarily power off the processor and power it on again, to
restart the system.
3
Make all the setting changes and additional settings to the
required initial state.
4
In the OPERATION menu, press F7 (PWR ON DEFINE).
Chapter 10 Setup Operations
10-33