Sony HDS-7100 User Manual page 42

Transformation Basics
Changing three-dimensional coordinate values with the numeric
keypad
Detent positions and resetting
3-6
Chapter 3 Three-Dimensional Transformations
The coordinates for the reference channel are constantly displayed
on the menu monitor. (See page 4-4.)
You can carry out a transformation by changing these values with
the numeric keypad, without using the trackball or Z-ring.
Use the following procedure to set coordinate values.
1
Press one of the X, Y or Z buttons, turning it on.
2
Enter the coordinate value for the selected axis from the
numeric keypad.
You can enter a value with up to four decimal places. It is
also possible to enter a difference from the current value.
3
If you entered the new value, press the ENTER button.
If you entered a difference, press the TRIM button.
This changes the coordinate value, and the output video
changes accordingly.
The three-dimensional axes have detent positions specified at
regular intervals along them.
Pressing the CTR button sets a coordinate value to the closest
detent.
Immediately pressing the CTR button once more, returns to the
default value.
RUN
CURSR
CTRL
SRCE TRGT
ASP
LOC LOC
SKEW
SIZE XYZ
PERS
AXIS
ORTHG ROT
LOC
X Y Z
VELO
CTR
HOLD
SEL/FINE
CTR button