Sony HDS-7100 User Manual page 79

Resetting parameters to their default values
For example, to return the "Lum" parameter of the "SOURCE
FLAT" item in the menu shown on page 4-11 to its default value
you can use either of the following methods.
• Using the control panel: Display the "SOURCE FLAT" line
in green, then double-click on the corresponding button in the
soft knob specification section of the numeric keypad, the
KNOB LEFT button.
• Using the mouse: Place the cursor on the "Lum" parameter,
then double-click the left mouse button.
Resetting all parameters in a single menu
To reset all parameters in the menu displayed in the active window
to their default values, use the following procedure, with either the
control panel or the mouse.
1
Click on the "R" in the upper right corner of the menu, or hold
down the SHIFT button and press the CLR WORK BUFF
button.
A pop-up window appears as follows.
CANCEL(EXIT)
2
• To carry out the reset, click on the "OK" in the pop-up
window, or press the ENTER button.
• To cancel the operation, click on the "CANCEL" in the pop-
up window, or press the EXIT button, or press the right
mouse button.
Parameter RESET?
OK(ENTER)
Chapter 4 Menu Operations
4-15