Enabling Or Disabling Quick Configuration; Recording A Quick Configuration - Avaya 5900 Series Quick Start Configuration

Connecting and configuring the switch

Enabling or disabling Quick Configuration

Use the following commands to enable or disable Quick Configuration:
Before you begin
Quick Configuration requires a stack.
About this task
The new unit Quick Configuration can store a default configuration that applies to a new unit joining
the stack.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. To enable Quick Configuration, enter the following command:
quickconfig enable
3. To disable Quick Configuration, enter the following command:
no quickconfig enable
4. To default Quick Configuration, enter the following command:
default quickconfig
Next steps
Use the quickconfig start-recording command to record a default configuration that applies
to new units joining the stack.

Recording a Quick Configuration

Use this procedure to record a Quick Configuration:
Before you begin
Quick Configuration requires a stack.
Quick Configuration must be enabled.
About this task
You can use the new unit Quick Configuration feature to create a default configuration that applies
to any new unit joining the stack. You can record the default values for VLAN IDs, port speed,
duplex mode, PVID, tagging, and spanning tree groups for the new unit without the need to reset the
stack.
October 2015 Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
44