Using Out-Of-Band Management With Management Virtual Ip Address - Avaya 4500 Technical Configuration Manual

exporter-ip
protocol-version
[enable<true|false>]
2.4 Using out-of-band Management with Management
Virtual IP address
On the ERS8600 and ERS8300, special consideration should be used when using the out-of-
band management port on the CPU card. By default, the switch will use the out-of-band IP
address assigned to the CPU card if there is a valid route to the IPFIX Collector even if a
management virtual IP address is configured. If you have two CPU cards, two out-of-band IP
addresses will be used one for each CPU card. If a virtual management IP address is used, you
should also enabled the udpsrc-by-vip parameter so that only the management virtual IP address
will used for IPFIX packets sent to the IPFIX collector. This allows you to only have to configure
one IP address for the switch on the IPFIX collector instead of a possible two if two CPU cards
are used. The configuration is as shown below.
CLI:

ERS-Switch(config)# sys mgmt-virtual-ip <ipaddr/mask>

ERS-Switch(config)# udpsrc-by-vip
PPCLI:

ERS-Switch# config sys set mgmt-virtual-ip <ipaddr/mask>

ERS-Switch# config sys set udpsrc-by-vip enable
Specifies the IP address of the exporter. If you do not specify
an exporter-ip, the source-ip is chosen from Virtual IP,
management IP, or outgoing interface IP based on collector-
ip reachability.
Selects the protocol version (ipfix|ipfixv9|preipfixv5). Default is
ipfixv9.
Set this to add the collector (true) or not add collectors (false).
Avaya Inc. – External Distribution
avaya.com
11