Configuring management IP addresses using ACLI
Displaying out-of-band management IPV6 information
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. To display all addresses for IPv6 interfaces, enter the following command at the command
prompt:
show ipv6 address interfaces
3. To display IPv6 management addresses, enter the following command at the command
prompt:
show ipv6 mgmt address [unit <1–8>]
4. To display IPv6 management default-gateway information, enter the following command at
the command prompt:
show ipv6 mgmt default-gateway
5. To display IPv6 management interface information, enter the following command at the
command prompt:
show ipv6 mgmt interface
6. To display the neighbor table for the IPv6 management port, enter the following command at
the command prompt:
show ipv6 neighbor interface mgmt
7. To display the routing table for the IPv6 management port, enter the following command at
the command prompt:
show ipv6 route mgmt
Example
Switch(config)#show ipv6 mgmt address
2013-08-06 17:32:00 GMT+02:00
Mgmt Switch Address: ::/0
Mgmt Stack Address:
Switch(config)#show ipv6 neighbor interface mgmt
2013-08-06 17:32:45 GMT+02:00
===============================================================================
===============================================================================
NET ADDRESS/
PHYSICAL ADDRESS
------------------------------------------------------------------------------
4149:4:4:360::/
00:19:e1:55:07:00
4149:4:4:360::1/
00:19:e1:4d:7c:9c
4149:4:4:360::2/
00:19:e1:55:07:00
fe80::219:e1ff:fe55:700/
00:19:e1:55:07:00
October 2015
UTC time: 2013-08-06 15:32:00
4149:4:4:360::2/59
UTC time: 2013-08-06 15:32:45
Neighbor Information
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
PHYS
TYPE
STATE
INTF
O-1
LOCAL
REACHABLE
O-1
DYNAMIC REACHABLE
O-1
LOCAL
REACHABLE
O-1
LOCAL
REACHABLE
LAST
UPD
0
17061
16847
16847
68