Chapter 6: Configuring management IP
This chapter provides procedural information you can use to assign, clear, and view in-band and
out-of-band management IP addresses and gateway IP addresses.
Configuring out-of-band management using EDM
Use this procedure to configure the out-of-band management IP address, subnet mask, and default
gateway.
About this task
When you physically connect Ethernet RJ-45 management port for standalone switch or stack to
your network and assign an IP address to the port, you can use the management port to access the
switch or stack using Telnet, SSH, SNMP, HTTP, and HTTPS.
Note:
The out-of-band management IP address must be different than the switch or stack in-band
management IP address.
Procedure
1. From the navigation pane, double-click Edit.
2. In the Edit tree, click Chassis.
3. In the Chassis tree, click Switch/Stack.
4. In the Switch/Stack work area, click the Management IP tab.
5. To configure out-of-band management parameters for a switch, double-click table cells as
required.
6. On the toolbar, click Apply.
7. On the toolbar, you can click Refresh to verify the out-of-band management configuration.
October 2015
addresses using EDM
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
76