Displaying Local Alarms - Avaya 5900 Series Quick Start Configuration

Verification
Example
The following displays the output from the show boot command.
Switch#show boot
Unit Agent Image Secondary Image Active Image Diag Image Active Diag
----- ----------- --------------- ------------ ---------- -----------
1 7.0.0.066
* - Unit requires reboot for new Active Image to be made operational.
# - Unit requires reboot for new Diag to be made operational.
Switch#show boot diag
Unit Diag Image Active Diag
----- ---------- -----------
1 0.0.0.2c
# - Unit requires reboot for new Diag to be made operational.
Switch#show boot image
Unit Agent Image Secondary Image Active Image
----- ----------- --------------- ------------
1 7.0.0.066
* - Unit requires reboot for new Active Image to be made operational.
Switch#show boot image primary
Unit Agent Image Active Image
----- ----------- ------------
1 7.0.0.163
* - Unit requires reboot for new Active Image to be made operational.
Variable definitions
Use the definitions in the following table to use the show boot command.
Variable
diag
image [primary |
secondary]
Important:
When the currently loaded and operational software status is displayed for a stack, the unit
number is replaced by the word All.

Displaying local alarms

You can view local alarms to monitor alarm conditions.
Local alarms are raised and cleared by applications running on the switch. Local alarms are an
automatic mechanism run by the system and do not require any additional user configuration. The
October 2015
7.0.0.042 7.0.0.066
0.0.0.2c
7.0.0.042 7.0.0.066
7.0.0.163
Definition
Displays only information for the agent load.
Displays information about the image load. Options are:
• primary—display primary image software version.
• secondary—display secondary image software version.
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
0.0.0.2c 0.0.0.2c
80