Configuring A Domain Name Server; Resolving Domain Names To Ip Addresses - Avaya 5900 Series Quick Start Configuration

Configuring management IP addresses using ACLI
the USB ip.cfg file download succeeded, all parameters read from the file show are present
in the switch and part of the runtime configuration.

Configuring a Domain Name Server

Use this procedure to set the default DNS domain name for the switch.
Note:
This default domain name is appended to all DNS queries or commands that do not already
contain a DNS domain name.
Procedure
1. Log on to the Global Configuration mode in ACLI.
2. At the command prompt, enter the following command:
ip domain-name <DNS_domain name>
Variable definitions
The following table describes the parameters for the ip domain-name command.
Variable
<DNS_domain_name>

Resolving domain names to IP addresses

Use this procedure to set the domain name servers the switch uses to resolve a domain name to an
IP address.
About this task
A switch can have up to three domain name servers specified for this purpose.
Note:
To enter all three server addresses you must enter the command three times, each with a
different server address.
October 2015
Value
Specify the default domain name to be used.
The default form of this command is default ip
domain-name.
The no form of this command is no ip domain-name.
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
72