Displaying Out-Of-Band Management Information - Avaya 5900 Series Quick Start Configuration

Configuring management IP addresses using ACLI
Variable
<A.B.C.D>
<subnet_mask>
netmask <A.B.C.D>
default-gateway <A.B.C.D>
Important:
The out-of-band management IP addresses for all stack units must belong to the same subnet.

Displaying out-of-band management information

Use this procedure to display IPv4 address out-of-band management configuration information for a
switch or stack.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
show ip mgmt [switch | all | route]
3. To display the management port link status, enter the following command:
show mgmt-port status
Example
Switch>show ip mgmt all
Unit Ip Address
----- --------------- --------------- --------------- ------------- ---------
Stack 149.4.5.178
1 149.4.5.179
2 149.4.5.180
October 2015
Netmask Gateway
255.255.255.240 149.4.5.177
255.255.255.240 149.4.5.177
255.255.255.240 149.4.5.177
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
Value
Specifies an out-of-band management IPv4 address.
DEFAULT: 0.0.0.0
Specifies the management subnet mask.
DEFAULT: 0.0.0.0
Specifies the subnet mask associated with the out-
of-band management IP address.
DEFAULT: 0.0.0.0
Note:
Although netmask appears as an optional
parameter with the ip mgmt address
command, Avaya recommends that you change
the netmask when you dynamically change the
out-of-band management IP address for a
switch or stack.
Specifies the management default gateway. Only
specify an out-of-band default gateway if you are not
routing the management IP.
Link / Speed
Up 1000F
Up 1000F
Up 1000F
Status
Enabled
Enabled
Enabled
60