Configuring A Management Route - Avaya 5900 Series Quick Start Configuration

Note:
In a stack environment, the base unit is identified as Stack in the Unit column.
Variable definitions
The following table describes the parameters for the show ip mgmt command.
Variable
all
route
Note:
If you do not enter a variable with the show ip mgmt command, out-of-band management
configuration information for the local switch is displayed.

Configuring a management route

Use this procedure to configure a management route. In Layer 3 mode, If you configure
management routes you can access both the out-of-band and in-band management addresses.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. To assign an IP management route, enter the following command at the command prompt:
ip mgmt route <destination-IP> <destination-netmask> <destination-
gateway>
3. To clear an IP management route, enter the following command at the command prompt:
no ip mgmt route <destination-IP> <destination-netmask>
<destination-gateway>
Variable definitions
The following table describes the parameters for the ip mgmt route command.
October 2015
Value
Displays out-of-band management configuration
information for all units within a stack.
Displays management VLAN information.
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
Configuring a management route
61