Displaying In-Band Ipv6 Management Information - Avaya 5900 Series Quick Start Configuration

no ipv6 defaul-gateway
Example
Switch>enable
Switch#config terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#ipv6 address stack 2005::2/64
Switch(config)#ipv6 default gateway 2005::1
Switch(config)#ipv6 address switch 2005::3
Switch(config)#ipv6 address unit 2 2005::4
Switch(config)#ipv6 address unit 3 2005::5
Variable definitions
The following table describes the parameters for the ip address command.
Variable
switch
stack
unit <1–8>
<WORD>
default-gateway <WORD>
Note:
If you do not specify a parameter with the ipv6 address command, the system automatically modifies the
stack IPv6 address when in stack mode, and modifies the switch IPv6 address when in standalone mode.

Displaying in-band IPv6 management information

Use this procedure to display the stack and switch in-band management IPv6 addresses, and the in-
band default-gateway IPv6 address.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. To display the configured in-bank management IPv6 address, enter the following at the
command prompt:
show ipv6 address [stack][switch][unit <1–8>]
3. To display IPv6 default-gateway information, enter the following at the command prompt:
show ipv6 default-gateway
October 2015
Value
Specifies an in-band management IPv6 address for
an individual switch (standalone or stack unit).
Specifies an in-band management IPv6 address for
the stack.
Specifies an in-band management IPv6 address for
a specific stack unit. Values range from 1–8.
Specifies an in-band management IPv6 address.
Specifies the default gateway IPv6 address.
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
Displaying in-band IPv6 management information
63