Sony DVS-9000 User Manual page 120

Key disable: When the snapshot is recalled, the key settings remain
Effect dissolve: The transition from the state before the snapshot recall to the
Auto transition: An auto transition starts the instant the snapshot is recalled.
GPI output: A GPI output is sent to the allocated GPI port the instant the
Table of available attributes
The attributes that can be used depend on the region, as follows.
Attribute
Cross-point hold
Key disable
Effect dissolve
Auto transition
GPI outputs
a) Applicable only as temporary attributes, but not applicable by a menu operation.
b) Applicable only by a menu operation.
For more details, see "Saving and Recalling Snapshots" in Chapter 14
(Volume 2).
120
Snapshots
unchanged. This can be set independently for each keyer.
snapshot settings is carried out smoothly, by a dissolve. The dissolve
duration can be set in the Snapshot menu.
The auto transition setting is valid only for M/E-1, M/E-2, M/E-3, and
PGM/PST.
Note
If both effect dissolve and auto transition are selected as attributes, the auto
transition takes precedence.
snapshot is recalled.
The trigger type depends on the switcher GPI output settings made in the
Setup menu.
For details, see "Interfacing With External Devices (Device Interface
Menu)" under "Setup Relating to Switcher Processor" in Chapter 16
(Volume 2).
M/E-1 and PGM/PST
Yes
a) Yes
Yes
Yes
b) Yes
Yes: Can be used No: Cannot be used
Region
USER 1 to USER 2 DME 1 to DME 4
Yes Yes
No No
Yes Yes
No No
Yes No