Key Memory; Blink - Sony DVS-9000 User Manual

Sub mask: This uses the wipe generator signal or the signal selected on the

Key Memory

The key memory function allows the keyer settings on each cross-point button
to be automatically stored, so that the next time the same cross-point button is
selected these settings are recalled automatically.
There are two modes for key memory: simple mode and full mode.
The parameters stored in each mode are as follows.
Simple mode: key type, clean mode (including the plane setting for chroma
Full mode: All settings except transition (the same parameters as simple mode,

Blink

The blink function provides the following effects.
Key blink: The key is inserted and deleted at the specified frequency.
Edge blink: Key fill and key edge fill are interchanged at the specified
The blink settings are in the Transition menu for each key. (See "Blink
Function" (page 222).)
44
Keys
mask source.
When the box generator is selected, a rectangular mask is formed. You can
adjust the positions of the four sides of the box separately.
When the pattern generator is selected, you can select the pattern and apply
modifiers.
utility 1 bus on the M/E or PGM/PST bank, as the mask source.
When the wipe generator is selected, the patterns and the pattern modifiers
are the same as in a wipe transition.
keying), key position, key inversion, and adjustment values for the
particular key type (Clip, Gain, Density, Filter, etc. This includes color
vector key, wipe pattern key, key wipe pattern key, and chroma key.
However, in the case of a chroma key, it excludes color cancel, Y balance,
foreground CCR, window, and shadow.)
[Fine Key], key modifiers, main and sub mask settings, chroma key
detailed settings, and so on)
You can also set the frequency and the proportion of the cycle for which
the key is inserted.
frequency. You can specify both the frequency and the proportion of the
cycle for which the interchange occurs.