Setup Relating To The Router Interface And Tally Interface - Sony DVS-9000 User Manual

Setup Relating to the Router Interface and Tally
Interface
Carry out settings relating to the interface with the routing switcher, and
settings relating to the tally interface.
You can make the following settings.
Router interface setup (Router)
• Matrix Size: Assign the switcher matrix of each switcher processor to S-Bus
space, and select the matrix size and positioning level, source address
settings, and so on.
• External Box: To obtain the signal selection status of external devices with
a parallel input, assign a matrix as an external selector in the S-Bus space.
Make the matrix size, assignment level, source address, and other settings.
Tally interface setup (Tally)
Group tally settings (Group Tally)
• Tally Group: Select the group tally (Gp1 to 4 or Gp5 to 8) which can be
used.
• S-Bus Tally Enable: Specify S-Bus tally enabled or disabled.
Wiring information input (Wiring)
Input the information which specifies the physical wiring between switcher
and routing switcher or between two routing switchers.
Tally enable settings (Tally Enable)
Specify the destination to be the reference for tally generation, and make
various settings.
• Tally Type: Specify the tally type. The tally types which can be specified are
as follows:
• Destination: Specify the address and level.
• Tally Enable: Specify the timing at which a tally is enabled.
Copy (Tally Copy)
Copy the tally information pertaining to a particular source to a different
source.
132
Setup
When Group Tally is Gp1 to 4: R1, R2, R3, R4, G1, G2, G3, G4
When Group Tally is Gp5 to 8: R5, R6, R7, R8, G5, G6, G7, G8
Enable: Always enabled.
Disable: Always disabled.
Tally Input No.: Follow the tally input status.