Chapter 4: Verifying the System
Method 4: GPS Measurement Verification Procedure
Selecting the Test
Do This
1 Start the application program by going to the
Start menu, select Programs, Agilent E74xx.
2 Create a new project called:
Verification Test 4 (GPS).
3 Click Collection and select the GPS VFP
(Virtual front Panel).
4 Select measurement types: Satellites or
Statistics
NOTE
If the GPS receiver is configured for TAIP or NMEA, you can not see the
satellite bar chart.
4-20 Wireless Solutions Getting Started Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Additional Information
The software starts.
The Measurement or Hardware configuration is
shown.
You can use the Automatic Configuration wizard to
help set up the GPS receiver. For more
information, refer to
"Automatic Configuration" on
page 2-5
Assuming the GPS antenna is properly located
and the GPS receiver has a fix, the current location
parameters, such as latitude, longitude, velocity,
and altitude are displayed as shown in
Figure
4-6.