Table of Contents
Advertisement
Chapter 2: Setting Up Your System
Configuring Multiple Receivers and Phones
7. Configure each phone individually as follows:
NOTE
When you describe (name) a project, the more descriptive you are, the easier
it will be later to distinguish among resources when you are creating
measurements that use similar or multiple resources.
8. Select Collection mode to start the measurements.
Multiple Receivers and Phones
Refer to
150)" on page 2-81
multiple phones. There are no special considerations for installing both
multiple phones and multiple receivers.
sample setup.
Before you begin the hardware installation procedure, please review
"Hardware Installation Tips" on page
2-84 Wireless Solutions Getting Started Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
a. In Configuration mode, select the Hardware tab.
b. Double-click the phone icon or select the phone icon and click
to display the Hardware editor. Or, click
c. Enter a description for the phone.
d. In the Hardware Type box, select the phone type.
e. Click the Port Selections and Port Settings tabs to modify and confirm
the correct COM port setting for the phone. The port selection should
be serial. Select the Com port you are using.
f.
Use the default port settings or use the values according to the
PCMCIA Socket I/O card you are using.
g. Click
when you are satisfied with the settings.
OK
"Multiple Receivers" on page 2-74
for information about installing multiple receivers and
to add a new phone.
Add
and
"Multiple Phones (Option
Figure 2-27 on page 2-86
2-3.
Modify
illustrates a
Advertisement
Table of Contents
