Table of Contents
Advertisement
Chapter 4: Verifying the System
Method 4: GPS Measurement Verification Procedure
Method 4: GPS Measurement Verification
NOTE
If you have an Agilent digital receiver, make sure that you have tested the
receiver using either method 1
(page
It is recommended that you know the GPS position, the longitude and latitude,
of where you do the test.
Setting Up the Hardware
Do This
1 Connect the GPS receiver as shown in
Chapter 2, "Setting Up Your
2 Click Configuration to review or modify the
existing GPS hardware settings.
3 Select the Hardware tab.
4 Highlight the appropriate GPS unit and click
Modify.
5 Use the information in
to establish the GPS protocol and serial port
settings for your particular GPS unit.
4-18 Wireless Solutions Getting Started Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Procedure
4-13) described earlier in this chapter.
System".
Table 4-5 on page 4-19
(page
4-3), method 2
(page
Additional Information
Refer to the section specific to the GPS you own.
You switch to Configuration mode.
You can use the Automatic Configuration wizard to
help set up the GPS attached to your system. For
more information refer to
Configuration" on page 2-5
You can now set the appropriate GPS protocol.
The serial port settings are Trimble factory
defaults. If you have difficulty determining your
serial port configuration, contact Trimble
Navigation.
4-10), or method 3
"Automatic
Advertisement
Table of Contents
