Table of Contents
Advertisement
Chapter 4: Verifying the System
Method 2: Measuring a Known Channel in the System
Method 2: Measuring a Known Channel in the
System
Preparing the Hardware
Do This
1 Connect the system as shown in
Figure
The Agilent receiver requires a 30 minute
warm-up period to meet the guaranteed
specifications.
2 Turn on the Agilent receiver.
Figure 4-4 System Configuration for Measuring a Known Channel in the System
4-10 Wireless Solutions Getting Started Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
4-4.
Additional Information
There is a three minute delay after power-up or
re-configuration, before the internal temperature
sensor is activated and measurements are
nominally correct.
To connect the receiver and laptop, refer to step 1
and step 2 of any of the procedures listed in
Chapter 2, "Receiver-Based System Setup"
Advertisement
Table of Contents
