Table of Contents
Advertisement
Chapter 4: Verifying the System
What You Will Find In This Chapter
What You Will Find In This Chapter
There are four methods you can use to verify your system. These methods are:
Method
1
2
3
4
If you have a phone-only system, use method 4 to verify your system. If you
have an Agilent digital receiver as part of your system, you need to use at least
2 methods. These are method 4 and either method 1, or 2, or 3. Method 1 and
2 provide the highest level of confidence. Method 3 should only be used if you
do not have a signal generator and there is no known channel in the system.
•
NOTE
•
4-2 Wireless Solutions Getting Started Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Additional Information
"Method 1: Using a Signal Generator" on page 4-3
"Method 2: Measuring a Known Channel in the System" on page 4-10
"Method 3: Measuring the Noise Floor" on page 4-13
"Method 4: GPS Measurement Verification Procedure" on page 4-18
The verification tests are only used to alert you to possible non-operating
conditions. To measure actual receiver specifications, the unit must be
measured in a controlled environment, using Agilent Technologies'
prescribed measurement techniques.
Before you start the verification procedures, familiarize yourself with the
system, by completing the online tutorial. See
Online
Tutorial".
Chapter 3, "Using the
Advertisement
Table of Contents
