Chapter 2: Setting Up Your System
Configuring Multiple Receivers and Phones
Configuring Multiple Receivers and Phones
The Agilent Wireless Solutions support up to four receivers (all options) and/
or four phones (option 150 only).
Multiple Receivers
NOTE
When connecting multiple receivers, it is recommend that you use the
automatic configuration wizard. For more information refer
Configuration" on page
When you configure multiple receivers, only one receiver (the master
receiver) is physically connected to the computer and is able to supply input
from the GPS. You attach an external GPS system (unless it has internal GPS)
to the master receiver only. The other receiver(s) receive their GPS signal
from the master receiver via the cabling shown in
receivers contain internal GPS systems, their GPS is ignored. When you
configure the receivers in the software, do not attempt to configure more than
one GPS receiver (the one provided by the master receiver).
If you are using an external GPS, refer to the appropriate section
(see
master receiver. The setup for multiple receivers is shown in
Before you begin the hardware installation procedure, please review
"Hardware Installation Tips" on page
2-74 Wireless Solutions Getting Started Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2-5.
Table 2-1 on page
2-7) for instructions on how to connect it to your
"Automatic
Figure
2-24. If other
Figure
2-3.
2-24.