Selecting the Test
NOTE
Verifying the System
Method 4: GPS Measurement Verification Procedure
Do This
1 Start the application program by going to the
Start menu, select Programs, Agilent E74xx.
2 Create a new project called:
Verification Test 4 (GPS).
3 Click Collection and select the GPS VFP
(Virtual front Panel).
4 Select measurement types: Satellites or
Statistics
If the GPS receiver is configured for TAIP or NMEA, you can not see the
satellite bar chart.
154
Additional Information
The software starts.
The Measurement or Hardware configuration is
shown.
You can use the Automatic Configuration wizard to
help set up the GPS receiver. For more
information, refer to
"Automatic Configuration" on
page 23
Assuming the GPS antenna is properly located
and the GPS receiver has a fix, the current location
parameters, such as latitude, longitude, velocity,
and altitude are displayed as shown in
Agilent Wireless Solutions
Figure
4-6.