Table of Contents
Advertisement
Chapter 4: Verifying the System
Method 2: Measuring a Known Channel in the System
Testing the Signal
Do This
In the Markers group, click Add and To Max.
NOTE
Wait for at least one minute before using the displayed marker value. The
system is set to display a running average of 32. With time, the marker value
will approach the value of the measured signal.
Passing the Test
If the signal trace is of an acceptable amplitude above the noise floor,
depending on the distance from transmitters and antenna placement, at the
appropriate frequency for the channel measured, the system passed the test.
Now continue with the
Procedure" on page
tests, refer to
additional information.
4-12 Wireless Solutions Getting Started Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
See This
The level and frequency are displayed at the
top-left corner of the Spectrum display.
"Method 4: GPS Measurement Verification
4-18. If you are having problems with setting up these
Chapter 5, "Solving Problems and Updating Your System"
for
Advertisement
Table of Contents
