Chapter 2: Setting Up Your System
Receiver-Based System Setup
Trimble Placer GPS 400 or SVeeSix
The setup for the receiver with a Trimble Placer GPS 400 or SVeeSix receiver
is shown in
receiver, a standard, straight-through, RS-232 9-pin cable is required.
Before you begin the hardware installation procedure, please review
"Hardware Installation Tips" on page
Figure 2-5 Trimble Placer GPS 400 or SVeeSix
NOTE
The Trimble Placer SVeeSix Plus operates from 9 to 32 VDC (NO internal
battery backup). The red wire must be tied to the positive side of the power
supply. The black wire must be tied to the negative side of the power supply.
Optionally, the yellow wire may be tied to a backup power source, such as a
lithium battery (operates from 3.5 to 14 VDC).
2-14 Wireless Solutions Getting Started Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Figure
2-5. When using the Trimble Placer GPS 400 or SVeeSix
2-3.