Chapter 4: Verifying the System
Method 1: Using a Signal Generator
Figure 4-1 System Measurement Verification Setup Using a Signal Generator
Preparing the Hardware
Do This
1 Connect the system as shown in
but do not connect the signal generator
output.
The Agilent receiver requires a 30 minute
warm-up period to meet the guaranteed
specifications.
2 Depending on your system type, set the
frequency/power levels using
page
3 Check that the correct values are set on the
signal generator.
4-4 Wireless Solutions Getting Started Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Figure
4-1,
Table 4-1 on
4-6.
Additional Information
There is a three minute delay after power-up or
re-configuration, before the internal temperature
sensor is activated and measurements are
nominally correct.
For more information on how to connect the
receiver and laptop, refer to step 1 and step 2 of
any of the procedures listed in
Chapter 2,
"Receiver-Based System Setup"
Do not connect the signal generator at this
stage.